Thread Subject: (no subject)
Note
This archival content is maintained by WebAIM and NCDAE on behalf of TEITAC and the U.S. Access Board . Additional details on the updates to section 508 and section 255 can be found at the Access Board web site.
From: Gregg
Date: Mon, Mar 31 2008 10:20 AM
- Return to this mailing list's archives
- View all messages in this thread
- Next message in thread: None
- Previous message in thread: None
- Messages sorted by: Author | Thread | Date
RESENDING THIS CHART WHICH SENT SATURDAY BUT WAS EVIDENTLY WAS
SCRAMBLED FOR SOME
EWG - THIS IS NOT CHANGED FROM SAT VERSION IF YOU GOT IT OK
(OH THE MISC LETTERS IN THE TITLES ARE REMOVED - THEY WERE CUES TO
ME AND NOT SUGGESTED EDITS)
GREGG
From: = EMAIL ADDRESS REMOVED =
[mailto: = EMAIL ADDRESS REMOVED = ] On Behalf Of
Gregg Vanderheiden
Sent: Saturday, March 29, 2008 5:32 PM
To: TEITAC Committee
Cc: = EMAIL ADDRESS REMOVED = ; Whitney Quesenbery; Hoffman, Allen
Subject: [teitac-committee] Table at the end of the regulations
doc - TraceCorrections.
We added this at the last minute and I think we kind of confused
things.
The chart is provisions against FPC
The FPC are not specific to a particular disability (some are for
multiple
disabilities) so the chart doesn't map to the disability metadata
directly.
Also some things that would benefit people with physical
disabilities for
example - do not relate to the FPC for reach / strength. So they
should be
in the Physical disability metadata but should not map to the
reach/strength/manipulation FPC.
I did the best I could though.
It is interesting. We should do a similar one for the disability
metatdat
(oops - I mean one should be done - not EWG - and not for this
report.
I'll put that into the Trace Filter tool.
Edited chart (only) is attached.
Gregg
------------------------
Gregg C Vanderheiden Ph.D.
Professor - Depts of Ind. Engr. & BioMed Engr.
Director - Trace R & D Center
University of Wisconsin-Madison
<http://trace.wisc.edu/> FAX 608/262-8848
- Next message in Thread: None
- Previous message in Thread: None